USBMan Q&A Archived Forum Board

 
WWWBoard New Message: Message 443: Re: New PC - USB devices run painfully SLOW!!



WWWBoard: Message 443


[ Follow Ups ] [ Post Followup ] [ ]



   Posted by WillyLumpLump on 02/25/02 at 10:14 PM

Subject:   Re: New PC - USB devices run painfully SLOW!!


Message Posted

In Reply to: Re: New PC - USB devices run painfully SLOW!! posted by Bill D. on 02/25/02 at 9:56 PM:

: : Yes. I changed to this driver but it made no difference, so I changed back to the SIS drivers. Does my problem sound like one that is typically caused by the SIS drivers?

: SiS hardware show all sorts of issues inre USB. Sometimes they're fine though.

: Try unplugging all USB devices and reinstalling Windows over this installation.

: Bill

Thank you for your suggestion. I ran Windows setup this past weekend but the IBM PC camera was not unplugged. I will try again with all the devices unplugged.


: :
: : : : Installed IBM PC Camera and Wingman joystick (both USB).
: : : : The devices run so slowly that they are essentially useless.
: : : : The camera produces a picture totally out of sync with audio.
: : : : The joystick responds so slowly, Microsoft Combat Flight Sim can't be
: : : : played.
: : : : Both devices function well on an older Celeron machine.
: : : : I have updated to newest mobo bios. (020112L)
: : : : I have updated to newest 109 agp drivers from ECS.
: : : : I have installed newest approved Nvidia display drivers.
: : : : I have installed Microsoft Win 98 SE patch for USB.
: : : : I have removed the SIS USB controller drivers and tried default drivers.
: : : : I have turned off USB error correction.
: : : : I have eliminated all "ghost devices" in Device Manager from Windows "safe"
: : : : mode.
: : : : USB IRQ's are not being shared with other devices.
: : : : Newest drivers and software from Wingman.
: : : : Newest drivers and software for IBM camera.
: : : : On board LAN, sound and modem disabled in MB bios.

: : : : Except for this issue, my system runs very fast and very stable.
: : : : I'm going NUTS with this!
: : : : Any help from anyone is most welcome.

: : : : Configuration:

: : : : ECS - K7S5A - motherboard with LAN (newest bios)
: : : : 1.33 Athalon T-Bird
: : : : 256 Mb PC133 SDRAM (2x128)
: : : : 40 Gb 7200 RPM, ATA 100 W.D. HD
: : : : Hi-Val PCI Aureal Vortex A3D sound card (newest Aureal drivers)
: : : : Rockwell PCI modem (newest Conexant/Rockwell drivers from manufacturer)
: : : : NEC 1.44 Floppy
: : : : Buslink 52X CDROM
: : : : Cendyne 8x4x32 CDRW
: : : : Mid-Tower case with Codegen 350 watt PS
: : : : Visiontek Xtasy GEForce2 GTS-V AGP 32MbVideo (newest approved Nvidia
: : : : drivers)
: : : : Win98 SE (all updates applied)
: : : : Direct X 8.1

: : : : Thanks for reading this long sob story.




  

Follow Ups:





Post a Followup

Name:
E-Mail:
Subject:

Message to Post




 



[ Posting Rules | Follow Ups | Return to WWWBoard ]

Copyright © 1999-2002 USBMan®, Jeffery Roberts and J. M. Roberts.

USBMan® the USBMan Logo and Inside USB® are Registered Trademarks.

Intellectual Property Rights are Protected by US, Canadian and International Law.  All Rights Reserved.

Other names, logos and trademarks found at this site are the property of their individual respective owners.

Reproduction of original content without expressed, written permission is strictly forbidden