In Reply to: Re: usb [unknown device] posted by sentinel on 06/17/02 at 12:13 PM:
is is wats under components->usb:
Onbekend apparaat(=unknow device);) USB\VID_0000&PID_0000\1USB&ROOT_HUB&PCI&VEN_1045&DEV_C861&SUBSYS_C8611045&REV_10&BUS_00&DEV_03&FUNC_00
Onbekend apparaat USB\VID_0000&PID_0000\2USB&ROOT_HUB&PCI&VEN_1045&DEV_C861&SUBSYS_C8611045&REV_10&BUS_00&DEV_03&FUNC_00
Open hostcontroller voor PCI naar USB van ALi PCI\VEN_10B9&DEV_5237&SUBSYS_00000000&REV_03\BUS_00&DEV_0F&FUNC_00
Open hostcontroller voor PCI naar USB van OPTi (82C861) PCI\VEN_1045&DEV_C861&SUBSYS_C8611045&REV_10\BUS_00&DEV_03&FUNC_00
: ok here it goes:
: IRQ 0 Systeemtimer OK
: IRQ 1 Standaardtoetsenbord met 101/102 toetsen of Microsoft Natural Keyboard OK
: IRQ 2 Programmeerbare interruptcontroller OK
: IRQ 3 Communicatiepoort (COM2) OK
: IRQ 4 Communicatiepoort (COM1) OK
: IRQ 5 Rockwell 56K ACF II Fax+Data+Voice Modem OK
: IRQ 6 Standaarddiskettestationcontroller OK
: IRQ 7 Printerpoort (LPT1) OK
: IRQ 8 Systeem-CMOS/Real time klok OK
: IRQ 9 Windows Sound System (WSS) Device OK
: IRQ 10 Open hostcontroller voor PCI naar USB van OPTi (82C861) OK
: IRQ 10 IRQ Holder voor PCI-besturing OK
: IRQ 11 Open hostcontroller voor PCI naar USB van ALi OK
: IRQ 11 IRQ Holder voor PCI-besturing OK
: IRQ 12 PS/2 compatibele muispoort OK
: IRQ 13 Numerieke-gegevensprocessor OK
: IRQ 14 ALi M5229 PCI Bus Master IDE-controller OK
: IRQ 14 Primaire IDE-controller (dubbele fifo) OK
: IRQ 15 ALi M5229 PCI Bus Master IDE-controller OK
: IRQ 15 Secundaire IDE-controller (dubbele fifo) OK
: note: after the slot change.
: : Open System Information (MSINFO32.EXE) and navigate to Hardware Resources > IRQs. Click anywhere in the right pane and then press CTRL-A and then CTRL-C. You have copied that data to the clipboard. Paste that data in a reply here.
: : Bill
: : : I did move it to an other slot . its now in the first from the top. and they share the same irq first it was 11 now it is 10 and there are no conflics and shares with other irq....it simply shows 2 unknown devices that are disabled by windows....
: : : : Try moving the Opti to another slot. They must share the same IRQ.
: : : : Bill
: : : : : Hi i must say that i have almost tried everything i came across with no results what so ever. No here we go:
: : : : : under Me ( but also under 2k and win98 cuz i checked) in device manager under usb-controllers there are 2 unknown devices listed.
: : : : : The usb card is an opti 82C861 with 2 ports that seems to be installed and functioning correctly.
: : : : : The mainbord is a m575 of pcchips whitch seems to be discontinued: the last update goes to 062498. i updated, did a safe mode removal of the usb controller and rebooted. but nothing changed. There seems to be some usb onboard support because i can enable onchip usb in bios and also some usb for dos support. when i enable the onchip or onbord usb in bios the controllers are shown in device manager but there are no ports ( apparently the where optional)I tested with usbready and said that there were no problems. When i plug a device one port disappears and the other port shows an yellow exclamation mark. The device switches on for a sec. and dies.I tried installing it manually but did not accept. removing and booting brings back the 2 unknown devices. Question could it be solved with usb 2.0 or is it mainly my mainbord that is the problem cause i don't know anymore...some advice would be appriciated...