That driver is not in i386. Search your hard disks for it.

Honestly, Card readers, flash memory, modems and ActiveSync give us fits around here. They are just demanding and buggy devices in general. If you have IR capability, I would recommend that you try it.

Bill

: Tks Bill. But mine's a WinXP not Win98SE - is it the same? The solution posted seems to be applicable to Win98SE. I found only wmilib.sys in the C:\Windows\System32\Driver directory, but I can't find the wmidrv.sys file, neither could I find the file in the WindowsXP \i386 directory. Anyway, thks a lot. Bye.

: Regards,
: LKH

: : Refer to the post before yours. Try it and let me know.

: : Bill

: : : Hi,

: : : I've been having problems lately syncing my Casio E200 PPC with my PC since I replaced the motherboard from a generic Compaq Deskpro 350 (440BX chipset) to a ECS P6VXA (VIAŽ VT82C694X (NB) & VT82C686A/B (SB)), both running WindowsXP.

: : : On the 440BX mobo, I had no problem syncing the Casio E200 attached to its PC-Card adaptor JK-864PU. As the Compaq was a P-II, I replaced it with a Celeron 900MHz based ECS mobo. Since then I began to experience problem: I can sync the E200 directly with the PC without the adaptor - ActiveSync 3.5 worked brilliantly. When I put on the PC-card adaptor, ActiveSync can't "see" the E200 anymore (intermittently gave a "Unknown USB Device" or sometimes it may recognise "Casio USB Sync 2002" then nothing happened). I repeated the configurations on a couple of machines, I get varying results:

: : : A. Compaq Armada 1750 (running WinXP) - can sync with E200 directly, but cannot sync when JK-864PU used.

: : : B. Compaq Armada 1700 (running Win2k) - can sync with E200 directly, but cannot sync when JK-864PU used.

: : : C. Compaq Deskpro Pentium II 350MHz (running WinXP) - can sync with E200 directly AND also no problem sync with JK-864PU.

: : : D. Dell Dimension 4500 Pentium 4 1.6GHz running Win2k - can sync with E200 directly AND also no problem sync with JK-864PU.

: : : E. Creative PC Pentium III - can sync with E200 directly AND also no problem sync with JK-864PU running Win98 and Win2k.

: : : I tried the latest VIA 4-in-1, USB Filter, PCI latency patch, removing USB drivers in SAFE mode, BIOS setting, etc. that were recommended in this website - nothing seems to work.

: : :
: : : IRQ 0 System timer OK
: : : IRQ 1 Standard 101/102-Key or Microsoft Natural PS/2 Keyboard OK
: : : IRQ 3 Communications Port (COM2) OK
: : : IRQ 4 Communications Port (COM1) OK
: : : IRQ 5 VIA AC'97 Audio Controller (WDM) OK
: : : IRQ 5 3Com EtherLink 10/100 PCI TX NIC (3C905B-TX) OK
: : : IRQ 6 Standard floppy disk controller OK
: : : IRQ 8 System CMOS/real time clock OK
: : : IRQ 9 Microsoft ACPI-Compliant System OK
: : : IRQ 10 VIA Rev 5 or later USB Universal Host Controller OK
: : : IRQ 10 VIA Rev 5 or later USB Universal Host Controller OK
: : : IRQ 10 OPTi 82C861 PCI to USB Open Host Controller OK
: : : IRQ 12 PS/2 Compatible Mouse OK
: : : IRQ 13 Numeric data processor OK
: : : IRQ 14 Primary IDE Channel OK
: : : IRQ 15 Secondary IDE Channel OK

: : : Any advice (other than go get a DELL)? Million thanks!

: : : Regards,
: : : LKH