In Reply to: Re: usb not working, clean xp install, only have usb mouse posted by Jason on 06/07/02 at 2:04 PM:
For some reason, the 4-in-1 drivers are not "taking". Otherwise, the name VIA would be all throughout the IRQ table.
Try manually changing the USB controller drivers to VIA.
Bill
: Strange, i've got the same mobo K7VZA rev.3 in the office. XP recognizes a "VIA Rev. 5 or later USB Controller".
: Check the Plug&Play section of the bios. There's the "Reset Configuration Data" switch. After switching to enable, the bios will rearrange the irqs.
: Jason
: : I did a clean install yesterday, but PRIOR to that clean install it was xp installed over win2k. These problems are occuring with the clean install of winXP.
: : I have installed the 4 in 1 drivers and the USBfilter, multiple times.
: : I just flashed the new bios in.
: : Out of the items you listed to change in the BIOS, i was only able to find two, which I changed as following:
: : P2C/C2P concurrency:changed from enabled to disabled
: : PCI Master Time Out:changed from 01x32 to disabled
: : There is no room physically to move my sound card to another pci slot, so I have simply taken it out of the computer completely. I could not find "Reset Configuration Data" in the BIOS.
: : Before I reformatted I backuped the entire c drive to my d drive, and I have been trying to point the hardware installer to the cbackup\winnnt\system32\drivers (which is where I assume the old drivers were located) but it continues to give me the message drivers not found, unable to install, etc etc.
: : This is the new IRQ map, I have reenabled the secondary usb ports.
: : IRQ 0 System timer OK
: : IRQ 1 PC/AT Enhanced PS/2 Keyboard (101/102-Key) OK
: : IRQ 3 Communications Port (COM2) OK
: : IRQ 4 Communications Port (COM1) OK
: : IRQ 5 Universal Serial Bus (USB) Controller OK
: : IRQ 5 Universal Serial Bus (USB) Controller OK
: : IRQ 6 Standard floppy disk controller OK
: : IRQ 8 System CMOS/real time clock OK
: : IRQ 10 NVIDIA GeForce2 MX/MX 400 OK
: : IRQ 11 SMC EZ Card 10/100 PCI (SMC1211TX) #2 OK
: : IRQ 13 Numeric data processor OK
: : IRQ 14 Primary IDE Channel OK
: : IRQ 15 Secondary IDE Channel OK
: : I still have the same problem, everytinme windows boots up, it says detected new hardware,-- "Universal Serial Bus (USB) Controller" and ends up not finding the driver for it.
