Did they upgrade NT or load a new image?

Bill

: Our MIS folks recently installed Win2K Pro on my pc, which replaced NT 4.0, in order to provide usb support for digital camera work. When I plug in my Sandisk reader, I don't get a msg back that the pc recognizes a new hdware dev, etc. If I go to Explorer, I do see a new "f" drive created. I click on "f", msg is to insert disk..when I insert the camera's memory card, I get a msg back that I have UNPLUGGED a mass storage device and all sorts of dire msgs. That msg will keep repeating until I click "ok." Now, the card reader works fine on 3 other pc's with Win2K Pro. We had previously installed Kodak and Sandisk software on my pc, which might have been a mistake. Never did get the Kodak software to install properly.
: All my checks with Device Mgr, etc., says all is well.
: MS ACPI & Intel (R) 82801BA/BAM SMBus Controller are on IRQ9. Intel (R) 82801BA/BAM USB Univ Host Controller -2442 is on IRQ19..not shared.
: I think the MIS boys are afraid they will have to remirror this pc...hard to get them back. Being pretty much a rookie myself, I would appreciate any help.
: CVA